Honda Fit manuals

Honda Fit: Engine Oil/Air Separator Installation

  1. Remove all of the old liquid gasket from the oil/air separator mating surfaces, the bolts, and the bolt holes.

  1. Clean and dry the oil/air separator mating surfaces.

  1. Apply liquid gasket (P/N 08717-0004, 08718-0003, 08718-0004, or 08718-0009) to the engine block mating surface of the oil/air separator and to the inside edge of the threaded bolt holes. Install the component within 5 minutes   of applying the liquid gasket.

    NOTE:

    • Apply a 1.5 mm (0.059 in) diameter bread of liquid gasket along the broken line (A).

    • If you apply liquid gasket P/N 08718-0012, the component must be installed within 4 minutes.

    • If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply new liquid gasket.

  1. Install the oil/air separator (A).

    NOTE:

    • Wait at least 30 minutes before filling the engine with oil.

    • Do not run the engine for at least 3 hours after installing the oil/air separator.

  2. Install the PCV hose (B).

See also:

Maintenance Items Under the Hood
...

Fuel Tank Replacement
Drain the fuel tank until it is less than half full. Reinstall the fuel tank unit without connecting the fuel tank unit 4P connector and the quick-connect fitting (feed l ...

Dashboard/Steering Hanger Beam Disassembly/Reassembly (Page-2)
From the front of the dashboard (A), remove the screws. @font-face{font-family: "Honda_SymbolMarkeng";src:url(/statics/ho_prod_2/txt/Honda_SymbolMark_ ...

© 2024 Copyright www.hfitinfo.com