Honda Fit: Engine Oil Replacement
-
Allow the engine to reach operating temperature (fan comes on at least twice).
-
Remove the drain bolt (A), and drain the engine oil.
-
Reinstall the drain bolt with a new washer (B) and torque to specification.
-
Refill the engine with the recommended oil.
Capacity
At Oil Change:
3.4 L (3.6 US qt)
At Oil Change Including Filter:
3.6 L (3.8 US qt)
After Engine Overhaul:
4.2 L (4.4 US qt)
-
Run the engine for more than 3 minutes, then check the oil level and for any oil leakage.
-
If the Maintenance Minder required engine oil replacement, reset the Maintenance Minder, and this procedure is complete. If the Maintenance Minder did not require engine oil replacement, go to step 7.
-
Turn the ignition switch to LOCK (0).
-
Connect the HDS to the DLC.
-
Turn the ignition switch to ON (II).
-
Make sure the HDS communicates with the vehicle and the ECM/PCM. If it does not communicate, troubleshoot the DLC circuit.
-
Select GAUGE in the BODY ELECTRICAL with the HDS.
-
Select ADJUSTMENT in GAUGES with the HDS.
-
Select MAINTENANCE MINDER in the ADJUSTMENT with the HDS.
-
Select RESET in the MAINTENANCE MINDER with the HDS.
-
Select RESETTING THE ENGINE OIL LIFE with the HDS.
See also:
Warranty Coverages
U.S. Owners
Your new vehicle is covered by these warranties:
New Vehicle Limited -covers your new vehicle, except for the battery,
emissions control systems, and accessories against defects in mat ...
A/T Housing Reverse Idler Gear Installation (A/T)
Lightly coat the reverse idler gear shaft (A), the needle bearing (B),
and new O-rings (C) with lithium grease.
Assemble the new O-rings and the needle bearing on the reverse ...
Fuel Pump/Fuel Gauge Sending Unit Replacement
Remove the fuel tank unit.
Remove the fuel level sensor (fuel sending unit) (A) from the fuel tank
unit (B).
Check these items before installing the fuel tank ...
Categories
