Remove the oil pump.
Measure the connecting rod end play with a feeler gauge (A) between the connecting rod (B) and the crankshaft (C).
Connecting Rod End Play
Standard (New): |
0.15пјЌ0.35 mm (0.006пјЌ0.013 in) |
Service Limit: |
0.40 mm (0.015 in) |
If the connecting rod end play is beyond the service limit, install a new connecting rod, and recheck. If it is still beyond the service limit, replace the crankshaft.
To check crankshaft end play, push the crankshaft firmly away from the dial indicator by prying, and zero the dial against the end of the crankshaft. Then pull the crankshaft firmly back toward the indicator by prying; the dial reading should not exceed the service limit.
Crankshaft End Play
Standard (New): |
0.10пјЌ0.35 mm (0.0039пјЌ0.0138 in) |
Service Limit: |
0.45 mm (0.0177 in) |
If the end play is beyond the service limit, replace the thrust washers, and recheck. If it is still beyond the service limit, replace the crankshaft.
Address Calculation
The destination icon shows only the
approximate location of a destination
address. This occurs if the number of
possible addresses is different from the
number of actual addresses on a block. For
...
MAP Sensor Replacement
Disconnect the MAP sensor connector (A).
Remove the MAP sensor (B).
Install the parts in the reverse order of removal with a new O-ring (C).
...
Reporting Errors
You can help to improve database
accuracy by reporting any errors you
encounter.
• Report errors in freeways and main
“verified” roads shown in black on the
map at http://mapreporter.navteq ...