Honda Fit manuals

Honda Fit: Connecting Rod and Crankshaft End Play Inspection

  1. Remove the oil pump.

  1. Measure the connecting rod end play with a feeler gauge (A) between the connecting rod (B) and the crankshaft (C).

    Connecting Rod End Play

    Standard (New):

    0.15пјЌ0.35 mm (0.006пјЌ0.013 in)

    Service Limit:

    0.40 mm (0.015 in)

  1. If the connecting rod end play is beyond the service limit, install a new connecting rod, and recheck. If it is still beyond the service limit, replace the crankshaft.

  1. To check crankshaft end play, push the crankshaft firmly away from the dial indicator by prying, and zero the dial against the end of the crankshaft. Then pull the crankshaft firmly back toward the indicator by prying; the dial reading should not exceed the service limit.

    Crankshaft End Play

    Standard (New):

    0.10пјЌ0.35 mm (0.0039пјЌ0.0138 in)

    Service Limit:

    0.45 mm (0.0177 in)

  1. If the end play is beyond the service limit, replace the thrust washers, and recheck. If it is still beyond the service limit, replace the crankshaft.

See also:

Rear Seat Control Cable Replacement
NOTE: Take care not to tear or damage the seat covers. Put on gloves to protect your hands. Take care not to kink the cable. The left rear seat is shown, the right rear ...

Obtaining Navigation Update Data
Honda is continually expanding the scope of the navigation system. Navigation system software upgrades may be made available periodically, usually in the fall of each year. To purchase an updat ...

Warm Up TWC Removal/Installation
NOTE: If the warm up TWC is damaged internally, inspect the under-floor TWC for debris. Raise the vehicle on a lift. Remove the bolts (A). Lower the vehicle. ...

© 2024 Copyright www.hfitinfo.com