Honda Fit: Transmission End Crankshaft Oil Seal Installation - In Car
Special Tools Required
- Driver Handle, 15 x 135L 07749-0010000
- Oil Seal Driver Attachment, 96 mm 07ZAD-PNAA100
-
Remove the transmission.
-
M/T model
-
A/T model
-
-
M/T model: Remove the pressure plate, the clutch disc, and the flywheel.
-
A/T model: Remove the drive plate.
-
Clean and dry the crankshaft oil seal housing.
-
Apply a light coat of new engine oil to the lip of the crankshaft oil seal.
-
Using the driver handle, 15 x 135 L (A), and the oil seal driver attachment, 96 mm (B), to drive a new crankshaft oil seal squarely into the engine block to the specified installed height.
-
Measure the distance between the cylinder block (A) and the crankshaft oil seal (B).
Oil Seal Installed Height
0.2пјЌ1.2 mm (0.008пјЌ0.047 in)
-
M/T model: Install the flywheel, the clutch disc, and the pressure plate.
-
A/T model: Install the drive plate.
-
Install the transmission.
-
M/T model
-
A/T model
-
See also:
ATF Replacement (A/T)
NOTE: Keep all foreign particles out of the transmission.
Warm up the engine to normal operating temperature (the radiator fan
comes on), and turn the engine off.
Raise the vehic ...
Indicators
...
Rear Stabilizer Bushing Replacement
Raise and support the vehicle.
Remove the stabilizer bushing (A) from the axle beam.
@font-face{font-family:
"Honda_SymbolMarkeng";src:url(/st ...
Categories
