Clutch Wave-Plate Phase Difference Inspection (A/T)
Place the clutch wave-plate (A) on a surface plate, and set a dial
indicator (B) on the wave-plate.
Find the bottom (C) of a phase difference of the wave-plate, zero the
di ...
Automatic Transmission
■Creeping
The engine may run at a higher idle speed and creeping increases:
• Immediately after the engine starts.
• When the heating and cooling system is in use.
Keep the brake pedal f ...
Wheel Speed Sensor Replacement
Front
Turn the ignition switch to LOCK (0).
Remove the grommet (A), then disconnect the wheel speed sensor connector
(B).
@font-face{font-famil ...