NOTE: If the warm up TWC is damaged internally, inspect the under-floor TWC for debris.
Raise the vehicle on a lift.
Remove the bolts (A).
Lower the vehicle.
Remove the A/F sensor (Sensor 1).
Remove the EGR pipe.
Remove the cover (A).
Remove the bolts (B) and the nuts (C).
Remove the WU-TWC (D).
Install the parts in the reverse order of removal with new gaskets (E).
Brake Light, Taillight, Back-Up Light and Rear Turn
Signal Light Bulbs
When replacing, use the following bulbs.
Brake/Taillight: 21/5 W
Back-Up Light: 16 W
Rear Turn Signal Light: 21 W (Amber)
1. Pry on the edge of the cover using a flat-tip
screwdriver to remove ...
Immobilizer System
The immobilizer system prevents a key that has not been pre-registered from
starting the engine. Each key contains electronic transmitters that use
electronic
signals to verify the key.
Pay att ...
Clutch Hose Replacement (M/T)
NOTE:
Replace the clutch hose if it is twisted or cracked, or if it leaks.
Use fender covers to avoid damaging painted surfaces.
Do not spill brake fluid on the vehicle; it may ...