Honda Fit: Emissions

See also:

Inboard Joint Side
Remove the boot bands. Be careful not to damage the boot. If the boot band is welded type (A), cut the boot band. If the boot band is a double loop type (B), lift up the ban ...

Driveshaft Installatio
NOTE: Before starting installation, make sure the mating surfaces of the joint and the splined section are clean. Apply about 5 g (0.18 oz) moly 60 paste (P/N 08734-0001) to the contact ar ...

Regulator Valve Body Disassembly, Inspection, and Reassembly (A/T)
Clean all parts thoroughly in solvent, and dry them with compressed air. Blow out all passages except the air check valve filter. Inspect the regulator valve body for scoring and ...