Raise the vehicle on the lift.
Drain the engine coolant.
Disconnect the ECT sensor 2 connector (A), then remove the harness clamp (B).
With A/C: Remove the A/C compressor clutch connector (C) from the clamp, then remove the harness clamps (D).
Disconnect the lower radiator hose (A).
A/T model: Disconnect the ATF cooler hoses (B), then plug the hose and line.
Lower the vehicle on the lift.
Remove the coolant reservoir (A).
Disconnect the radiator fan motor connector (A), then remove the harness clamp (B).
With A/C: Disconnect the A/C condenser fan motor connector (C), then remove the harness clamp (D).
Disconnect the upper radiator hose (A).
Remove the radiator upper brackets (A).
Pull up the radiator (A).
With A/C: Remove the A/C condenser fan shroud assembly (B).
Remove the radiator fan shroud assembly (C), the radiator cap (D), the ECT sensor 2 (E), and the drain plug (F).
Reassemble the radiator with new O-rings (G).
Install the radiator. Make sure the lower cushions (H) are set securely.
Install the radiator upper brackets (A).
Connect the upper radiator hose (A).
Connect the radiator fan motor connector (A), then install the harness clamp (B).
With A/C: Connect the A/C condenser fan motor connector (C), then install the harness clamp (D).
Install the coolant reservoir (A).
Raise the vehicle on the lift.
Connect the lower radiator hose (A).
A/T model: Remove the plug from the hose and the line, then connect the ATF cooler hoses (B).
Connect the ECT sensor 2 connector (A), then install the harness clamp (B).
With A/C: Install the A/C compressor clutch connector (C) to the clamp, then install the harness clamps (D).
Lower the vehicle on the lift.
Refill the radiator with engine coolant, and bleed the air from the cooling system.
Clean up any spilled engine coolant.
Driver's Airbag Replacement
NOTE:
If replacing the driver's airbag after deployment, refer to
Component Replacement/Inspection After Deployment for a
complete list of other parts that must also be replaced.
...
Playing Tracks in Folders
AUDIO button (in USB mode)
►Folder
Change the folder if the tracks are stored in a folder structure.
1. Select a folder.
► The system displays the track
list.
2. Select a tra ...
As required by the FCC
1)This device complies with Part 15 of the
FCC Rules and Canadian RSS-210/RSSGen.
Operation is subject to the following
two conditions: (1) this device may not
cause harmful interference, and (2 ...