Honda Fit: Water Pump Inspection
-
Remove the right front wheel.
-
Remove the splash shield.
-
Loosen the water pump pulley mounting bolts (A).
-
Remove the drive belt.
-
Remove the water pump pulley mounting bolts, then remove the water pump pulley (B).
-
Turn the water pump pulley counterclockwise, and check that it turns freely. If it does not turn freely, replace the water pump.
NOTE: When you check the water pump, you may see a small amount of ‘‘weeping'' from the bleed holes (A). This is normal.
-
Install the water pump pulley (A), and loosely install the water pump pulley mounting bolts (B).
-
Install the drive belt.
-
Tighten the water pump pulley mounting bolts.
-
Install the splash shield.
-
Install the right front wheel.
See also:
TPMS System Description (USA models)
TPMS Control Unit Inputs and Outputs at the
20P Connector
@font-face{font-family:
"Honda_SymbolMarkeng";src:url(/statics/ho_prod_2/txt/Honda_SymbolM ...
Inspection
Raise and support the vehicle.
Remove the front wheels.
Check the thickness (A) of the inner pad (B) and the outer pad (C). Do not
include the thickness of the back ...
Searching for Music
AUDIO button (in iPod® mode)
Search for music using the iPod® menu.
1. Select the menu tab.
2. Select a search category (e.g.,
Album).
3. Select an item.
► The selection begins ...
Categories
