Honda Fit manuals

Honda Fit: Driveshaft Disassembly

Special Tools Required

See also:

Transmission Side - Release Bearing Inspection
Check the play of the release bearing by spinning it by hand. If there is excessive play or noise, replace the release bearing. NOTE: The release bearing is packed with grease. Do not ...

Driveshaft Installatio
NOTE: Before starting installation, make sure the mating surfaces of the joint and the splined section are clean. Apply about 5 g (0.18 oz) moly 60 paste (P/N 08734-0001) to the contact ar ...

Removal
Do the battery terminal disconnection procedure. Remove the drive belt. Remove the intake manifold. Disconnect the alternator connector (A) and the p ...

© 2026 Copyright www.hfitinfo.com