Honda Fit manuals

Honda Fit: M/T Differential Thrust Clearance Adjustment (M/T)

Second generation (2007-2024) / Honda Fit 2007-2024 Repair Manual / Powertrain / Driveline / Differentials / M/T Differential Thrust Clearance Adjustment (M/T)

Special Tools Required
  1. Remove the left driveshaft side oil seal from the transmission housing.

  1. If you remove the 80 mm shim (A) from the transmission housing (B), reinstall the same sized shim. That's the same size as the one you removed.

  1. Install the differential assembly (A) into the clutch housing.

  1. Install the transmission housing onto the clutch housing, then tighten the 8 mm flange bolts in a crisscross pattern in several steps.

    Specified Torque:

    8 x 1.25 mm

    27 N·m (2.8 kgf·m, 20 lbf·ft)

  1. Use the 40 mm driver handle to bottom the differential assembly in the clutch housing.

  1. Measure the clearance between the 80 mm shim and the bearing outer race in transmission housing.

    Standard:

    0.01-0.1 mm (0.0004-0.004 in)


  1. If the clearance exceeds the standard, select a new 80 mm   shim from the following table. If the clearance measured in step 6   is within the standard, go to step 10.

    80 mm Shim:

    Type

    Thickness

    A

    1.00 mm (0.0394 in)

    B

    1.10 mm (0.0433 in)

    C

    1.20 mm (0.0472 in)

    D

    1.30 mm (0.0512 in)

    E

    1.40 mm (0.0551 in)

    F

    1.50 mm (0.0591 in)

    G

    1.60 mm (0.0630 in)

    H

    1.70 mm (0.0669 in)

    J

    1.80 mm (0.0709 in)

    K

    1.05 mm (0.0413 in)

    L

    1.15 mm (0.0453 in)

    M

    1.25 mm (0.0492 in)

    N

    1.35 mm (0.0531 in)

    P

    1.45 mm (0.0571 in)

    Q

    1.55 mm (0.0610 in)

    R

    1.65 mm (0.0650 in)

    S

    1.75 mm (0.0689 in)

  1. Remove the bolts and the transmission housing.

  1. Replace the thrust shim selected in step 7, then recheck the clearance.

  1. Install a new left driveshaft side oil seal.

  1. Reinstall the transmission housing.

See also:

Rocker Arm Assembly Removal
Remove the cylinder head cover. Loosen the rocker arm adjusting screws (A). Unscrew the rocker shaft mounting bolts two turns at a time in the sequence shown. ...

Clutch Pedal, Clutch Pedal Position Switch, and Clutch Interlock Switch Adjustment (M/T)
NOTE: For a cruise control problem, check the clutch pedal position switch. For a clutch interlock operation problem, check the clutch interlock switch. Remove the driver' ...

Rear Seat Disassembly/Reassembly
Special Tools Required KTC Trim Tool Set SOJATP2014 *Available through the Honda Tool and Equipment Program; call 888-424-6857 NOTE: Use the appropriate tool from the KTC trim to ...

© 2024 Copyright www.hfitinfo.com