Honda Fit: Receiver/Dryer Desiccant Replacement (With A/C)
NOTE: Install the receiver/dryer as quickly as possible to prevent the system from absorbing moisture from the air.
-
Remove the A/C condenser.
-
Remove the bolts from the A/C condenser, then remove the receiver/dryer (A), the bracket (B), and the O-rings (C).
-
Install the receiver/dryer in the reverse order of removal. Replace the O-rings with new ones, and apply a thin coat of refrigerant oil (SP-10) before installing them. Be sure to use the correct O-rings for HFC-134a (R-134a) to avoid leakage.
See also:
Ignition Switch
The ignition switch has four positions: LOCK (0), ACCESSORY (I), ON (II), and
START (III).
LOCK (0) - You can insert or remove the key only in this position.
To turn the key, push it in slightly ...
Off-road Tracking
INFO button
► Setup ►Other
►Vehicle
The navigation system can be set to display white off-road tracking dots
(“breadcrumbs”) on the map screen whenever you drive into an are ...
Engine Block Drain Bolt/Sealing Bolt Installation
NOTE:
When installing the drain bolt (A), always use a new washer.
When installing the sealing bolt(s) (B), always use a new bolt(s) and
washer(s) (C).
...
Categories
