Special Tools Required
Remove the center console.
Remove the parking brake lever, then remove the access panel from the floor.
Disconnect the suction line (A) from the fuel tank unit, and connect a vacuum pump/gauge, 0-30 in Hg (B), to the hose as shown.
Start the engine, and check the vacuum:
If there is vacuum, go to step 5.
If there is no vacuum, replace the fuel filter.
Turn the ignition switch to LOCK (0).
Attach the fuel pressure gauge attachment. Then connect the vacuum pump/gauge (A) to the suction line (B), and apply vacuum to the line:
If the line holds vacuum, check for a blockage in the suction line. If there is a blockage, replace the suction line.
If the line does not hold vacuum, go to step 7.
Raise the vehicle on a lift.
Remove the fuel tank mount bracket (A).
Disconnect the breather line (A). Attach the fuel pressure gauge attachment, then plug the suction line (B) with a rubber cap (C).
Turn Signals
The turn signals can be used when the ignition
switch is in ON .
...
Fuel Pressure Regulator Replacement
Remove the fuel tank unit.
Remove the reservoir (A).
Remove the clip (B) and the ground wire (C), then remove the bracket (D).
Remove the clip (E), then r ...
Tire Pressure Monitoring System (TPMS) - Required Federal Explanation
Maximum Tire Pressure
Max Press - The maximum air pressure the tire can hold.
Maximum Tire Load
Max Load - The maximum load the tire can carry at maximum air pressure.
Tire PressureMonitoring Sys ...