Honda Fit: Side Vent
Click here for an interactive version of this procedure (driver's, passenger's).
NOTE: Take care not to scratch the dashboard or its related parts.
-
Pull the upper portion (A) of the side vent (B) toward you to release the hooks (C), then remove the side vent.
-
Install the side vent in the reverse order of removal, and push the hooks into place securely.
Driver's side
Passenger's side
See also:
Torque Converter Housing Countershaft Bearing Replacement (A/T)
Special Tools Required
Adjustable Bearing Puller, 25пјЌ40 mm 07736-A01000B
Driver Handle, 15 x 135L 07749-0010000
Oil Seal Driver Attachment, 58 mm 07JAD-PH80101
Remove the countersh ...
Pilot Bearing Inspection
Inspect the crankshaft pilot bearing for wear and damage.
Inspect the inside surface of the crankshaft pilot bearing with your
finger. If the crankshaft pilot bearing is not smoot ...
Alternator Brush Inspection
Measure the length of both brushes (A) with a vernier caliper:
If either brush is shorter than the service limit, replace the brushes,
go to step
20.
If brush length ...
Categories
