Honda Fit: Dashboard Vent Removal/Installation

See also:

Mainshaft Disassembly, Inspection, and Reassembly (A/T)
Inspect the thrust needle bearings and the needle bearings for galling and rough movement. Inspect the splines for excessive wear and damage. Check the shaft bearing s ...

Change Lever Clearance Inspection (M/T)
Measure the clearance between the change lever (A) and the select lever (B) with a feeler gauge (C). If the clearance is more than the service limit, go to step 2. ...

M/T Differential Carrier/Final Driven Gear Replacement (M/T)
Loosen the bolts in a crisscross pattern in several steps, then remove the final driven gear (A) from the differential carrier (B). Install the final driven gear with the cham ...