Open the glove box. Remove the glove box stop on each side, then let the glove box hang down.
Pull the dust and pollen filter assembly (A) out from the blower unit.
Remove the filter (A) from the housing (B), and replace the filter.
Install the filter in the reverse order of removal. Make sure that there is no air leaking out of the blower unit.
Side Defogger Vent Trim Removal/Installation
Special Tools Required KTC Trim Tool Set SOJATP2014 *Available through the Honda Tool and Equipment Program; call 888-424-6857 NOTE: Take care not to scratch the dashboard or its ...
Transmission Side - Release Bearing Installation
Apply high temp urea grease (P/N 08798-9002) to the release fork (A), the release fork bolt (B), the release bearing (C), and the release bearing guide (D) in the shaded areas, then set th ...
Ball Joint Boot Inspection/Replacement
Special Tools Required Bearing Driver Attachment, 40 mm 07GAF-SE00200 Check the ball joint boot for weakness, damage, cracks, and grease leaks. NOTE: If the ball joint boot is ...