Honda Fit manuals

Honda Fit: Fuse Access Panel Removal/Installation

NOTE:

  1. Pull the fuse access panel (A) back by hand to release the hooks (B) and the clips.

  2. Fastener Locations: Clip, 2BBA
  1. Pivot the fuse access panel (A) down on the shafts (B) until it is even with the floor, then pull it rearward to remove its hinges (C) from the shafts. If equipped, disconnect the VSA off switch connector (D), and detach the harness clip (E).

  2. ABCDEBC??
  1. Install the panel in the reverse order of removal, and note these items:

    • If the clips are damaged or stress-whitened, replace them with new ones.

    • For some models: Make sure the VSA off switch connector is plugged in properly.

    • Push the clips and the hooks into place securely.

See also:

Braking System
Your vehicle is equipped with front disc brakes. The brakes on the rear wheels are drum. A power assist helps reduce the effort needed on the brake pedal. The anti-lock brake system (ABS) helps yo ...

VSA® (Vehicle Stability Assist), aka ESC (Electronic Stability Control), System
VSA® helps to stabilize the vehicle during cornering if the vehicle turns more or less than what was intended. It also assists in maintaining traction on slippery surfaces. It does so by regu ...

Wipers and Washers
NOTICE Do not use the wipers when the windshield is dry. The windshield will get scratched, or the rubber blades will get damaged. NOTICE In cold weather, the blades may freeze to the windshie ...

© 2024 Copyright www.hfitinfo.com