Honda Fit: Installation
-
Install the alternator (A), then tighten the alternator mounting bolts (B).
-
Connect the alternator connector (A) and the positive alternator cable (B). Make sure the crimped side of the ring terminal faces away from the alternator when you connect it.
-
Install the harness clamp (C) to the alternator.
-
Install the intake manifold.
-
Install the drive belt.
-
Do the battery terminal reconnection procedure.
See also:
A/T System Description - Clutches and Gears (A/T)
Clutches and GearsThe five-speed automatic transmission uses
hydraulically-actuated clutches to engage or disengage the transmission
gears. When hydraulic pressure is introduced into the clut ...
Fuses
The vehicle’s fuses are contained in three fuse boxes.
The interior fuse box is behind the driver’s coin tray. To access it, remove
the tray by turning the dial counterclockwise then pulling ...
A/F Sensor Replacement
Special Tools Required
O2 Sensor Wrench Snap-on S6176 or equivalent, commercially available
Remove the cowl cover and the under-cowl panel.
Disconnect the A/F se ...
Categories
