Measure the length of both brushes (A) with a vernier caliper:
If either brush is shorter than the service limit, replace the brushes, go to step 20.
If brush length is OK, go to step 21.
Alternator Brush Length
Standard (New): |
23 mm (0.91 in) |
Service Limit: |
18 mm (0.71 in) |
Unsolder the brush leads from the voltage regulator/brush holder assembly with a 100 W soldering iron (A), then replace the brushes.
Changing Your Route
DEST button (when en route)
This section describes how to alter your route, add an interim “waypoint”
(pit stop),
choose a different destination, cancel your current destination, and continue ...
Heater Unit - Core Replacement Part-1
SRS components are located in this area.
Review the SRS component locations
and
the precautions and procedures
before doing repairs or service.
Do the battery t ...
Power Windows System Description
Anti-pinch Power Window OperationThe system is composed of the power window control unit (built into the power
window master switch) and the driver's power window motor.
The driver's p ...