Remove the rotor (A).
Inspect the rotor shaft for scoring, and inspect the bearing journal surface in the drive-end housing (B) for seizure marks:
If either the rotor or the drive-end housing is damaged, replace the alternator.
If both the rotor and the drive-end housing are OK, go to step 10.
Remove the rear bearing (A) using the puller as shown.
Use a hand press to install a new rear bearing (A). Apply pressure only on the inner race to avoid damaging the bearing.
Remove the front bearing retainer plate (A).
Drive out the front bearing with a brass drift (A) and a hammer.
Horn Test/Replacement
'09-11 models
Remove the front grille cover.
Disconnect the 1P connector (A) from the horn (B).
@font-face{font-family:
"Honda_SymbolMark ...
Getting Started Tutorial
1 Press the INFO button.
2 Select Voice Info.
3 Select Getting started.
You can also view the available
command list for each system. See
Command Help on this page.
4 Select Using the talk b ...
Visiting Your Dealer
If you have a question that you cannot
resolve using the available help resources,
you can consult your dealer. Please identify
the specific issue (e.g., error occurs when
you enter a specific add ...