Honda Fit manuals

Honda Fit: Exploded View

FRONT BEARINGRETAINERFRONT BEARINGPULLEYDRIVE-END HOUSINGSTATORREAR BEARINGSPACERTERMINALINSULATORRECTIFIERVOLTAGE REGULATOR/BRUSH HOLDER ASSEMBLYREAR HOUSINGROTOR110 N·m (11.2kgf·m, 81 lbf·ft)

Special Tools Required

NOTE: Refer to the Exploded View if needed during this procedure.

  1. Test the alternator and regulator before you remove them.

  1. Remove the alternator.

See also:

Brightness Control
When the parking lights are turned on and the ignition switch is in ON , you can use the (select/reset) knob to adjust instrument panel brightness. Brighten: Turn the knob to the right. ...

Radio Theft Protection
Your vehicle’s audio system will disable itself if it is disconnected from electrical power for any reason. To make it work again, you must enter a specific five-digit code in the preset button ...

Alternator Brush Inspection
Measure the length of both brushes (A) with a vernier caliper: If either brush is shorter than the service limit, replace the brushes, go to step 20. If brush length ...

© 2026 Copyright www.hfitinfo.com