Honda Fit: Valve Stem-to-Guide Clearance Inspection
-
Remove the valves.
-
Subtract the O.D. of the valve stem, measured with a micrometer, from the I.D. of the valve guide, measured with an inside micrometer or ball gauge.
Take the measurements in three places along the valve stem and three places inside the valve guide.
The difference between the largest valve guide measurement and the smallest valve stem measurement should not exceed the service limit.
Intake Valve Stem-to-Guide Clearance
Standard (New):
0.020-0.050 mm (0.00079-0.00197 in)
Service Limit:
0.08 mm (0.0031 in)
Exhaust Valve Stem-to-Guide Clearance
Standard (New):
0.050-0.080 mm (0.00197-0.00315 in)
Service Limit:
0.11 mm (0.0043 in)
See also:
Introduction
Congratulations! Your selection of a 2008 Honda Fit was a wise investment.
It will give you years of driving pleasure.
One of the best ways to enhance the enjoyment of your new vehicle is to read
...
Removal (Part -1)
Do the battery terminal disconnection procedure.
Raise and support the vehicle.
Remove the front wheels.
Tilt the steering column all the way up and mov ...
Ignition Switch
The ignition switch has four positions: LOCK (0), ACCESSORY (I), ON (II), and
START (III).
LOCK (0) - You can insert or remove the key only in this position.
To turn the key, push it in slightly ...
Categories
