Front
Turn the ignition switch to LOCK (0).
Remove the grommet (A), then disconnect the wheel speed sensor connector (B).
Remove the bracket (C), the clip (D), and the wire guide rubber (E).
Remove the bolt and the wheel speed sensor (F).
Install the wheel speed sensor in the reverse order of removal, and note these items:
Do not twist the sensor wires.
If the wheel speed sensor comes in contact with the wheel bearing, it is faulty.
Make sure the grommet is installed properly.
Make sure there is no debris in the sensor mounting hole.
Rear
Turn the ignition switch to LOCK (0).
Pull back the carpet under the rear seat, then disconnect the wheel speed sensor connector (A).
Remove the grommet (B), the bracket (C), the clips (D), and the wire guide rubber (E).
Remove the bolt and the wheel speed sensor (F).
Install the wheel speed sensor in the reverse order of removal, and note these items:
Do not twist the sensor wires.
If the wheel speed sensor comes in contact with the hub bearing unit, it is faulty.
Make sure the grommet is installed properly.
Make sure there is no debris in the sensor mounting hole.
Adjusting the Seat Positions
Adjust the driver’s seat as far back as possible
while allowing you to maintain full control of
the vehicle. You should be able to sit upright,
well back in the seat and be able to
adequately ...
Authorized Manuals
Purchasing Factory Authorized Manuals (U.S. onl
The publications shown below can be purchased from Helm Incorporated. You can
order by phone or online:
• Call Helm Inc. at 1-800-782-4356 (credit ...
Center Console Removal/Installation
Special Tools Required
KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program; call
888-424-6857
Click here for an interactive version of this procedure (M ...