Honda Fit: VSA Off Switch Test/Replacement
NOTE: If the low tire pressure indicator turns ON, the VSA cannot be turned OFF. Check the tire pressure first.
-
Turn the ignition switch to LOCK (0).
-
Remove the driver's dashboard lower cover.
-
Push out the VSA OFF switch (A) from the driver's dashboard lower cover.
-
On the switch side, check for continuity between VSA OFF switch 5P connector terminals No. 1 and No. 2. There should be continuity when the button is released, and no continuity when the button is pressed.
-
On the switch side, check for continuity between VSA OFF switch 5P connector terminals No. 4 and No. 5. There should be continuity at all times.
-
If the continuity is not as specified, remove the cover (A), and replace the bulb (B).
-
Install the VSA OFF switch in the reverse order of removal.
See also:
Previous Destinations
INFO button
► Setup
►Personal Information►Previous Destinations
The navigation system maintains a list of your previously routed destinations
as a
shortcut for entering the s ...
Important Safety Precautions
■ Always wear your seat belt
A seat belt is your best protection in all types of collisions. Airbags are
designed to
supplement seat belts, not replace them. So even though your vehicle is e ...
Air Cleaner Removal/Installation
Disconnect the MAF sensor/IAT sensor connector(A), then remove the air
cleaner cover (B) and the air cleaner element (C).
NOTE: Be careful not to damage the MAF sensor/IAT sensor on the air ...
Categories
