Honda Fit: Rear Stabilizer Bushing Replacement
-
Raise and support the vehicle.
-
Remove the stabilizer bushing (A) from the axle beam.
-
Apply silicone spray (P/N08209-0001) to the new stabilizer bushing. This will ease installation of the bushing into the stabilizer and the axle beam.
NOTE: When spraying any agents that contain silicone, cover all the connectors, terminals, and switches in area with a protective cloth or plastic sheet.
-
Install the stabilizer bushing (A) into the axle beam by aligning the end face of the stabilizer bushing to the center of hole (B).
NOTE:
-
Securely install the stabilizer (C) into the stabilizer bushing groove (D).
-
Make sure the stabilizer bushing is not protrusion the end of the axle beam (E).
-
See also:
Center Console Removal/Installation
Special Tools Required
KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program; call
888-424-6857
Click here for an interactive version of this procedure (M ...
Driving to Your Destination
This section describes how to follow the route guidance to your destination,
and
choose the icons displayed on the map screen. ...
Parking Brake
To apply the parking brake, pull the lever up fully. To release it, pull up slightly,
push the button, and lower the lever. The parking brake indicator on the instrument
panel should go out when ...
Categories
