Honda Fit: Ball Joint Boot Inspection/Replacement
Special Tools Required
- Bearing Driver Attachment, 40 mm 07GAF-SE00200
-
Check the ball joint boot for weakness, damage, cracks, and grease leaks.
NOTE:
-
If the ball joint boot is damaged and leaks grease, replace the lower arm.
-
If the ball joint boot is weak and cracked but dose not leak grease, go to step 2. Replace the ball joint boot.
-
-
Remove the lower arm.
-
Remove the ball joint boot (A).
NOTE: Be careful not to damage the mating surface with ball joint boot of ball joint housing (B).
-
Pack the interior and lip (C) of a new ball joint boot with grease. Keep the grease off of the ball joint boot-to-lower arm mating surfaces (D).
-
Pack fresh grease into the base (E). Do not let dirt or other foreign materials get into the ball joint boot.
-
Install the boot on the ball joint, then squeeze it gently to force out any air.
-
Press the boot with the inner bearing driver attachment until the bottom seats (A) on the lower arm all the way around.
-
After installing a boot, wipe any grease off the exposed portion of the ball joint pin.
-
Install the lower arm.
See also:
Tire Labeling
The tires that came on your vehicle have a number of markings. Those you should
be aware of are described below.
Tire Size
Whenever tires are replaced, they should be replaced with tires of the ...
Protecting Larger Children
Checking Seat Belt Fit
To determine if a lap/shoulder belt properly fits a child, have the child put
on the seat belt, then ask yourself:
1. Does the child sit all the way back against the seat? ...
Home Addresses
INFO button
► Setup
►Personal Information►Home Address 1 or Home
Address 2
Set two home addresses that you frequently use.
1. Edit the name, address, and phone
number the s ...
Categories
