Honda Fit: Exploded View
Special Tools Required
- Ball Joint Remover, 28 mm 07MAC-SL0A202
- Hub Dis/Assembly Pin, 40 mm 07GAF-SE00100
- Driver Handle, 15 x 135L 07749-0010000
- Bearing Driver Attachment, 52 x 55 mm 07746-0010400
- Support Base 07965-SD90100
- Ball Joint Thread Protector, 10 mm 07AAF-SECA120
- Ball Joint Thread Protector, 14 mm 071AF-S3VA000
See also:
iPod®/USB Flash
If an error occurs while playing an iPod® or USB flash drive, you may see the
following error messages. If you cannot clear the error message, contact a
dealer.
...
Transmission Side - Release Bearing Inspection
Check the play of the release bearing by spinning it by hand. If there is
excessive play or noise, replace the release bearing.
NOTE: The release bearing is packed with grease. Do not ...
CKP Sensor Replacement
Raise the vehicle on a lift.
NOTE: Make sure the vehicle is level, because engine oil will drip out
when you remove the sensor.
Loosen the bolt (A). Remove the bolt (B) and ...
Categories
© 2026 Copyright www.hfitinfo.com