Honda Fit: Removal
NOTE: Do not allow dust, dirt, or other foreign materials to enter the steering gearbox.
-
Remove the steering gearbox.
-
Remove both tie-rod ends from the rack ends.
-
Remove the boot bands (A) and tie-rod clips (B). Pull the boot away from the ends of the steering gearbox. Repeat this step for the other side.
-
Hold the gearbox housing using a C-clamp (A) and wooden blocks (B) to a workbench as shown. Do not clamp the cylinder part of the gearbox housing in a vise.
-
Unbend the lock washer (A).
-
Unscrew both rack ends (A) with a wrench. Be careful not to damage the rack shaft surface with the wrench. Remove the rack end, the lock washer (B), the spacer (C), and the rubber stop (D).
See also:
Regulator Valve Body Disassembly, Inspection, and Reassembly (A/T)
Clean all parts thoroughly in solvent, and dry them with compressed air.
Blow out all passages except the air check valve filter.
Inspect the regulator valve body for scoring and ...
Rocker Arm and Shaft Disassembly/Reassembly
NOTE:
Identify each part as it is removed so that each item can be reinstalled
in its original location.
Inspect the rocker arm shaft and the rocker arms.
If reused, the ...
Numbers
...
Categories
