Honda Fit: Steering Rack End Removal and Installation

See also:

A/T Differential Backlash Inspection (A/T)
Install the driveshaft and intermediate shaft into the differential assembly, and place the axles on V-blocks   (A). Measure the backlash of the pinion gears (B) wit ...

Piston Installation
If the Crankshaft is Already Installed Set the crankshaft to bottom dead center (BDC) for each cylinder as its piston is installed. Remove the connecting rod caps, and check that ...

Starting System
Starter Overhaul Exploded View NOTE: Refer to the Exploded View if needed during this procedure. Armature Inspection and Test Remove the starter. Inspect the armature f ...