Honda Fit manuals

Honda Fit: Installation (Part -1)

  1. Before installing the steering gearbox, make sure that no grease is on the mating surface of the steering gearbox and the front subframe. To prevent the gearbox mounting bolts from loosening after the installation, remove any grease from the bolt holes.

  1. Install the pinion shaft grommet (A). Align the lug portion (B) in the pinion shaft grommet to the steering gearbox.

  2. AB
  1. Place the steering gearbox (A) on the front subframe (B).

  2. AB?10 x 1.25 mm60 NВ·m (6.1 kgfВ·m, 44 lbfВ·ft)Replace.?10 x 1.25 mm60 NВ·m(6.1 kgfВ·m, 44 lbfВ·ft)Replace.?10 x 1.25 mm59 NВ·m(6.0 kgfВ·m, 43 lbfВ·ft)Replace.?10 x 1.25 mm60 NВ·m(6.1 kgfВ·m, 44 lbfВ·ft)Replace.?10 x 1.25 mm59 NВ·m(6.0 kgfВ·m, 43 lbfВ·ft)Replace.C
  3. Loosely install the stiffener plates (C), and new gearbox mounting bolts, then tighten the bolts to the specified torque in the sequence shown.

  4. Turn the lip of the pinion shaft grommet to ease installation.

See also:

Exhaust Pipe and Muffler Replacement
NOTE: Use new gaskets and self-locking nuts when reassembling. ...

Safety When Performing Maintenance
Some of the most important safety precautions are given here. However, we cannot warn you of every conceivable hazard that can arise in performing maintenance. Only you can decide whether or not y ...

Engine Coolant
Specified coolant: Honda Long Life Antifreeze/Coolant Type 2 This coolant is premixed with 50% antifreeze and 50% water. Do not add any straight antifreeze or water. We recommend you check the en ...

© 2024 Copyright www.hfitinfo.com