Remove the harness clamp (A) from its clamp bracket (B) located in front of the left damper top.
Set up the engine support hanger (AAR-T1256). Carefully position the engine support hanger to the vehicle; position both cross-arm foot bases (C) over the harness clamp brackets on both sides, and position both front stands on the front bulkhead. Attach the hook to the universal eyelet, tighten the wing nut by hand, and lift and support the engine.
Disconnect the EPS motor angle sensor 8P connector (A) and torque sensor 6P connector (B) from the steering gearbox.
Disconnect the EPS motor 3P connector (C) by pushing the lock (D) and pulling up the lever (E).
Wrap the connectors with vinyl tape to avoid contamination from grease or water.
Remove the front cross-member brace (A).
Front Seat-Back Cover/Pad Replacement (Part -1)
Special Tools Required
KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program; call
888-424-6857
SRS components are located in this area.
Review the SRS c ...
Remote Transmitter
On Sport model
LOCK - Press this button once to lock all doors and the tailgate. Some
exterior lights will flash once. When you push LOCK twice within 5 seconds, the
horn will sound to verify t ...
Fuel Information
■ Fuel recomme
Unleaded gasoline, pump octane number 87 or higher
Use of lower octane gasoline can cause a persistent, heavy metallic knocking
noise
that can lead to engine damage.
■ ...