Honda Fit: Steering Gearbox Removal and Installation
Special Tools Required
- Ball Joint Thread Protector, 14 mm 071AF-S3VA000
- Ball Joint Thread Protector, 10 mm 07AAF-SECA120
- Universal Lifting Eyelet 07AAK-SNAA120
- 1.8 Support Bolt 07AAK-SNAA500
- Ball Joint Remover, 28 mm 07MAC-SL0A202
- Engine Support Hanger, A and Reds AAR-T1256
* Available through the Honda Tool and Equipment Program 888-424-6857.
Note these items during removal:
-
Use solvent and a brush, wash any oil and dirt off the end of the steering gearbox, but avoid any electrical parts. Blow dry with compressed air.
-
Lower the front subframe from the body then remove the steering gearbox.
- Removal (Part -1)
- Removal (Part -2)
- Removal (Part -3)
- Installation (Part -1)
- Installation (Part -2)
- Installation (Part -3)
See also:
Manual Transmission
The manual transmission is synchronized in all forward gears for smooth operation.
It has a lockout so you cannot shift directly from fifth to reverse. When shifting
up or down, make sure you pu ...
Important Safety Precautions
You’ll find many safety recommendations throughout this section, and throughout
this manual.
The recommendations on this page are the ones we consider to be the most important.
Always Wear Your ...
Floor Mats
If you remove a floor mat, make sure to re-anchor it when you put it back in
your vehicle.
A non-Honda floor mat may not fit your vehicle properly. This could prevent the
proper operation of th ...
Categories
