Honda Fit manuals

Honda Fit: EPS Control Unit Removal/Installation

  1. Do the battery terminal disconnection procedure.

  1. Remove the under-dash fuse/relay box.

  1. Disconnect EPS control unit connector A (11P) and connector B (16P) by pushing the lock (C) and pulling down the lever (D) from the EPS control unit.

  2. G6 x 1.0 mm 9.8 NВ·m (1.0 kgfВ·m, 7.2 lbfВ·ft)AF6 x 1.0 mm 9.8 NВ·m (1.0 kgfВ·m, 7.2 lbfВ·ft)BE6 x 1.0 mm 9.8 NВ·m (1.0 kgfВ·m, 7.2 lbfВ·ft)CD
  3. Loosen the bolt (E).

  4. Remove the bolt (F) and nut (G) from the EPS control unit bracket.

  5. Remove the EPS control unit with the bracket from the body.


  6. Install the EPS control unit in the reverse order of removal.

    NOTE:

    • Install the bracket with the EPS control unit as shown in position.

    • Connect EPS control unit connector A (11P) and connector B (16P), then confirm the connectors are fully seated.

  7. Do the battery terminal reconnection procedure.

  8. After installation, start the engine, allow it to idle, and turn the steering wheel from lock to lock several times. Make sure that the EPS indicator does not come on.

See also:

Headliner Removal/Installation (General information)
Special Tools Required KTC Trim Tool Set SOJATP2014 *Available through the Honda Tool and Equipment Program; call 888-424-6857 SRS components are located in this area. Review the SRS ...

Reset Factory Default Settings
INFO button ► Setup ►Other ►Reset Factory Default Reset all the settings on the Setup screens to their factory defaults. Select Yes. The following settings are reset: • Br ...

Side Curtain Airbags
The side curtain airbags help protect the heads of the driver and passengers in outer seating positions during a moderate-to-severe side impact. The side curtain airbags are most effective when an ...

© 2026 Copyright www.hfitinfo.com