Honda Fit: Brake Hose Replacement
 |
|
Do not spill brake fluid on the vehicle; it may damage the paint. If brake fluid gets on the paint, wash it off immediately with water. |
NOTE:
-
Before reassembling, check that all parts are free of dirt and other foreign particles.
-
Replace parts with new ones whenever specified to do so.
-
After removal, plug the ends of the hoses and the joints to prevent spilling brake fluid.
See also:
Synchro Sleeve and Hub Inspection and Reassembly (M/T)
Inspect gear teeth on all synchro hubs and the synchro sleeves for
rounded off corners, which indicate wear.
Install each synchro hub (A) in its mating synchro sleeve (B), and che ...
Emissions Testing
Testing of Readiness Codes
If you take your vehicle for an emissions test shortly after the battery has
been disconnected or gone dead, it may not pass the test.
This is because of certain ‘‘r ...
Valve Body and ATF Strainer Removal (A/T)
Remove the ATF feed pipe (A) from the regulator valve body (B).
Remove the ATF feed pipes (C) (D) from the servo body (E).
Remove the ATF strainer (F) (two bolts).
...
Categories
