Honda Fit: Brake Booster Replacement
-
Remove the air cleaner cover and the air cleaner case.
-
Remove the master cylinder.
-
Disconnect the brake booster vacuum hose (A) from the brake booster.
-
Remove the brake lines (A) from the clamp (B).
-
Remove the nut (C) on the canister and move the hose (D) out of the way.
-
Remove the engine wire harness clamp (A).
-
Remove the driver's dashboard undercover.
-
Remove the lock pin (A) and the clevis pin (B), then disconnect the clevis from the brake pedal.
-
Remove the brake booster mounting nuts (C).
-
Remove the brake booster (A) from the engine compartment.
notice -
Be careful not to damage the booster surfaces and threads of the booster stud bolts.
-
Be careful not to bend or damage the brake lines or other components hoses and lines.
NOTE: Use new booster gasket (B) during reassembly.
-
-
Install the brake booster in the reverse order of removal, and note these items:
-
Install the master cylinder after installing the brake booster.
-
Check the brake pedal height and free play after installing the master cylinder, and adjust it if necessary.
-
Bleed the brake system.
-
See also:
Mainshaft Bearing and Oil Seal Replacement (M/T)
Special Tools Required
Driver Handle, 15 x 135L 07749-0010000
Bearing Driver Attachment, 37 x 40 mm 07746-0010200
Bearing Driver Attachment, 52 x 55 mm 07746-0010400
Adjustable Bearing Puller, ...
Passenger's Power Window Switch Replacement
NOTE: The illustration shows front passenger's power window switch.
Remove the door panel:
Front passenger's
Rear
Remove the screws and t ...
Transmission Fluid
Automatic Transmission Fluid
Check the fluid level with the engine at normal operating temperature.
1. Park the vehicle on level ground.
Start the engine, let it run until the radiator fan comes ...
Categories
