Honda Fit: Disassembly
-
Raise and support the vehicle.
-
Remove the rear wheels.
-
Release the parking brake, and remove the brake drum.
-
Remove the tension pins (A) by pushing respective retainer spring (B) and turning the pin.
-
Remove the lower return spring (A), and remove the brake shoe assembly over the hub.
-
Remove the forward brake shoe (B) by removing the upper return spring (C), and disassemble the brake shoe assembly.
-
Remove the rearward brake shoe (D) by disconnecting the parking brake cable from the parking brake lever (E).
-
Remove the U-clip (A), the wave washer (B), and the pivot pin (C), and separate the parking brake lever (D) from the brake shoe (E).
See also:
Front Stabilizer Bar Replacement
Removal
Remove the front subframe.
Remove the steering gearbox from the front subframe.
Remove the flange bolts (A) and the bushing holders (B), then remove the
...
Exterior Care
Dust off the vehicle body after you drive.
Regularly inspect your vehicle for scratches on painted surfaces. A scratch on a
painted surface can result in body rust. If you find a scratch, promptly ...
MAF Sensor/IAT Sensor Replacement
Disconnect the MAF sensor/IAT sensor connector (A).
Remove the screws (B).
Remove the MAF sensor/IAT sensor (C).
Install the parts in the reverse order of removal ...
Categories
