Honda Fit: Inspection
-
Raise and support the vehicle.
-
Remove the front wheels.
-
Check the thickness (A) of the inner pad (B) and the outer pad (C). Do not include the thickness of the backing plate.
Brake pad thickness:
Standard:
10.0 mm (0.394 in)
Service limit:
1.6 mm (0.063 in)
-
If any part of the brake pad thickness is less than the service limit, replace the front brake pads as a set.
-
Clean the mating surfaces between the brake disc and the inside of the wheel, then install the front wheels.
Inner pad
Outer pad
See also:
Fuel Pump/Fuel Gauge Sending Unit Replacement
Remove the fuel tank unit.
Remove the fuel level sensor (fuel sending unit) (A) from the fuel tank unit
(B).
@font-face{font-family:
"Honda ...
Installation
Install the damper rubber mount (A) onto the damper unit. Position the
damper assembly (B) between the body and the axle beam.
NOTE: Be careful not to damage the body.
...
Intermediate Shaft Reassembly (A/T)
Exploded View
Special Tools Required
Oil Seal Driver, 65 mm 07JAD-PL90100
Bearing Driver Attachment, 52 x 55 mm 07746-0010400
Bearing Driver Attachment, 35 mm I.D. 07746-0030400
Driver ...
Categories
