Honda Fit: Front Brake Pad Inspection and Replacement
Special Tools Required
- Brake Caliper Piston Compressor 07AAE-SEPA101
 |
|
Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your health.
|
See also:
Alternator Reassembly
If you removed the pulley, put the rotor in the drive-end housing, then torque
its locknut to 110 N·m (11.2 kgf·m, 81 lbf·ft).
Remove any grease or any oil from the ...
Engine Compression Inspection
NOTE: After the inspection, you must reset the ECM/PCM. Otherwise, the
ECM/PCM will continue to stop the injectors from operating.
Allow the engine to reach operating temperature (fan comes o ...
A/T Housing Reverse Idler Gear Installation (A/T)
Lightly coat the reverse idler gear shaft (A), the needle bearing (B),
and new O-rings (C) with lithium grease.
Assemble the new O-rings and the needle bearing on the reverse ...
Categories
