Honda Fit manuals

Honda Fit: Washer Reservoir Replacement

  1. Remove the front bumper.

  1. Disconnect the 2P connector (A) and tubes (B) from the washer motor (C) and the washer fluid level switch (Canada models).

    Washer Reservoir Capacity:

    2.5 L (2.6 US qt):

    USA models

    4.5 L (4.8 US qt):

    Canada models

  2. CABD
  3. Remove the washer motor from the washer reservoir (D).

  1. Remove the bolts (A) and clips (B), then remove the washer reservoir (C).

  2. AACB
  3. Install the washer reservoir in the reverse order of removal. Check the washer motor operation.

See also:

Turn Signals
The turn signals can be used when the ignition switch is in ON . ...

Making a Call
Make calls by entering a number or using the imported phonebook, call history, or speed dial entries. You can control the HFL system using voice commands. When you say “Call by number” or ...

Piston Installation
If the Crankshaft is Already Installed Set the crankshaft to bottom dead center (BDC) for each cylinder as its piston is installed. Remove the connecting rod caps, and check that ...

© 2025 Copyright www.hfitinfo.com