Release airbag attachment wire A and airbag attachment wire B from the seat-back frame (C).
Passenger's seat: Remove the ODS unit cover (A).
Turn over the seat-back cover (B) and the pad (C) as needed.
Release the cover from the lower hooks (D).
Pull the cover upward to release it from the upper hook (E).
Passenger's seat: Disconnect the ODS unit harness connector (F) and the OPDS sensor connectors (G).
Passenger's seat: Detach the harness clips (A) fastening the OPDS sensor harnesses (B) and the ODS unit harness (C).
Passenger's seat: Pull out the side airbag harness (A) and the ODS unit harness (B) through the holes (C) in the seat-back pad (D) and the seat-back cover (E).
Audio System
You can play music from a wide array of media sources. You can also control
the audio system using voice commands. ...
Audio Antenna
Your vehicle is equipped with a removable
antenna at the rear of the roof.
NOTICE
Before using a “drive-through” car wash, remove the
antenna by unscrewing it by hand. This prevents the
ant ...
Piston Installation
If the Crankshaft is Already Installed
Set the crankshaft to bottom dead center (BDC) for each cylinder as its
piston is installed.
Remove the connecting rod caps, and check that ...