Honda Fit manuals

Honda Fit: Rear Seat Control Cable Replacement

NOTE:

  1. Remove the rear seat assembly.

  1. Remove the rear seat cushion.

  1. Remove the rear seat cushion cover/pad and the silencer.

  1. Fold the leg, and remove the wire tie (A).

  2. ABCDBB
  3. Disconnect the control cable (B) from the leg end (C) and cable bracket (D) of the seat cushion frame.

  4. Install the cable in the reverse order of removal, and note these items:

    • Replace the wire tie you removed with a new one.

    • Make sure the control cable is routed properly and connected securely.

    • Install the new cable end in the same position as the original cable end. Check the rear seat for proper tip-up operation. If necessary, adjust the position of the cable end and recheck.

See also:

Playing a Disc
To Play a CD All models except Sp To load or play CDs, the ignition switch must be in the ACCESSORY (I) or the ON(II) position. You operate the CD player with the same controls used for the rad ...

Address Calculation
The destination icon shows only the approximate location of a destination address. This occurs if the number of possible addresses is different from the number of actual addresses on a block. For ...

Basic Settings
INFO button ► Setup ►Other ►Basic Settings Set the map units to either miles or kilometers, and control the voice feedback from the navigation system. Select an item. The ...

© 2026 Copyright www.hfitinfo.com