Honda Fit: Front Passenger's Airbag Replacement (Installation)
Installation
-
Insert the hooks (A) of the front passenger's airbag housing into the new front passenger's lid, then insert the other hooks (B) into the panel.
NOTE:
-
Make sure there are no objects between the airbag and the front passenger's lid.
-
Make sure the airbag is fully seated, and make sure the front passenger's lid is not deformed or damaged after the airbag is in place.
-
Make sure the hooks are set properly.
-
-
Place the front passenger's airbag assembly (A) into the dashboard. Torque the new front passenger's airbag mounting bolts (B).
-
Install the screw (C) in the front passenger's lid.
-
Connect the front passenger's airbag inflator 4P connector (A) on the dashboard wire harness, then connect the connector clip. Reinstall the glove box.
-
Do the battery terminal reconnection procedure.
-
Clear any DTCs with the HDS.
-
After installing the front passenger's airbag, confirm proper system operation: Turn the ignition switch to ON (II), and check that the SRS indicator should comes on for about 6 seconds and then goes off.
-
Reinstall all removed parts.
See also:
Interior Care
Use a damp cloth with a mixture of mild detergent and warm water to remove
dirt.
Use a clean cloth to remove detergent residue.
Do not spill liquids inside the vehicle.
Electrical devices and ...
Door Glass Adjustment
NOTE: Check the weatherstrips and glass run channel for damage or deterioration,
and replace them if necessary.
Place the vehicle on a firm, level surface.
Remove these items:
...
Safe Driving
You can find many safety recommendations throughout this chapter, and
throughout this manual. ...
Categories
