Secondary Shaft Disassembly, Inspection, and Reassembly (A/T)
Inspect the thrust needle bearings and the needle bearings for galling
and rough movement.
Inspect the splines for excessive wear and damage.
Check the shaft bearing s ...
A/F Sensor Replacement
Special Tools Required
O2 Sensor Wrench Snap-on S6176 or equivalent, commercially available
Remove the cowl cover and the under-cowl panel.
Disconnect the A/F se ...
Center Console Removal/Installation
Special Tools Required
KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program; call
888-424-6857
Click here for an interactive version of this procedure (M ...