Removal
Make sure the front wheels are aligned straight ahead.
Do the battery terminal disconnection procedure, then wait at least 3 minutes before starting work.
Remove the driver's airbag.
Disconnect the cable reel 20P connector (A) from the cable reel, then remove the steering wheel bolt (B).
Confirm that the front wheels point straight ahead, then remove the steering wheel with a steering wheel puller. Do not tap on the steering wheel or steering column shaft when removing the steering wheel.
Remove the column covers.
Disconnect the cable reel 4P connector (A) and the cable reel 20P connector (B) from the cable reel (C).
Release the lock tab (A) under the cable reel connector with a 90
Steering Angle Sensor Replacement
SRS components are located in this area. Review the
SRS component locations and the
precautions and procedures.
NOTE: Do not damage or drop the combination switch as the steering angle ...
Selecting a Destination on the Map
Select a new destination when en route by selecting a location on the map.
1. Scroll the map to position the
cursor over your desired
destination, adjusting the map
scale as necessary. Press the ...
Countershaft Disassembly (M/T)
NOTE: Refer to the Exploded View in the countershaft reassembly, as needed,
when removing components pressed onto the countershaft.
Securely clamp the countershaft assembly in a bench vise wi ...