Honda Fit manuals

Honda Fit: SRS Component Replacement/Inspection After Deployment

Second generation (2007-2025) / Honda Fit 2007-2025 Repair Manual / Body / Restraints / Secondary / SRS Component Replacement/Inspection After Deployment

NOTE:

After a collision where the seat belt tensioners deployed, replace these items:

After a collision where the front airbag(s) deployed, replace these items:

After a collision where the side airbag(s) deployed, replace these items:

After a collision where a side curtain airbag has deployed, replace the items for the side(s) that deployed:

After a moderate to severe side or rear collision, inspect for any damage on the side curtain airbag or other related components. Replace the components as needed.

A-pillar trim

Always replace.

B-pillar trim

Quarter pillar trim

During the repair process, inspect these areas:

After the vehicle is completely repaired, turn the ignition switch to ON (II). If the SRS indicator comes on for about 6 seconds and then goes off, the SRS is OK. If the indicator does not function properly, check for DTCs with the HDS. If you cannot retrieve a code, do the SRS Symptom Troubleshooting.


Checking and Adjusting the Headliner/Pillar Trim Overlap

To prevent the side curtain airbag from deploying and damaging the pillar trim, the overlap between the headliner and pillar trim must be less than 8 mm (0.3 in).   To check the overlap, do this:

  1. Install the headliner (A) and the pillar trim (B).

  2. ABThis illustration shows A-pillar.
  1. Apply masking tape to the headliner to mark the upper edge of each pillar trim.

  2. This illustration shows A-pillar.
  1. Remove the pillar trim, and measure the headliner overlap.

    • If the overlap is less than 8 mm (0.31 in),   remove the tape, and install the pillar trim.

    • If the overlap is more than 8 mm (0.31 in),   go to step 4.

  2. EDGE OF HEADLINERLESS THAN8 mm (0.31 in)MASKING TAPEThis illustration shows A-pillar.
  1. Carefully trim the headliner with a utility knife, reducing the overlap to less than 8 mm (0.3 in).

  2. This illustration shows A-pillar.
  3. Remove the tape, and install the pillar trim.

See also:

Pairing from Phone Setup
PHONE button ► Phone Setup Use the Phone setup screen to pair an additional Bluetooth-compatible phone if a phone has been previously paired to the system. 1. Select Add/Select a Phone ...

Transmission End Cover Removal (A/T)
Special Tools Required Mainshaft Holder 07GAB-PF50101 Remove the bolts securing the ATF inlet line (D) and ATF filter holder (E), the line bolt and sealing washers, and remove the ATF in ...

Block and Piston Inspection
Remove the crankshaft and the pistons. Check the piston for distortion or cracks. Measure the piston skirt diameter (A) at a point 16 mm (0.63 in)   from ...

© 2025 Copyright www.hfitinfo.com