Honda Fit manuals

Honda Fit: Driver's Seat Position Sensor Replacement

Removal

NOTE: Do not turn the ignition switch to ON (II), and do not connect the battery cable while removing the driver's seat position sensor.

  1. Do the battery terminal disconnection procedure, then wait at least 3 minutes before starting work.

  1. Remove the recline cover.

  1. Disconnect the driver's seat position sensor 2P connector (A) on the driver's seat position sensor harness. Remove the TORX bolt (B) using a TORX T30 bit.

  2. BA
  1. Remove the driver's seat position sensor (A) through the space between the seat track and slide as shown.

  2. A

Installation

NOTE:

  1. Install the driver's seat position sensor (A) with a new TORX bolt (B).

  2. ACB11 Nح (1.1 kgfح, 8.1 lbfئt)Replace.
  3. Connect the driverӳ seat position sensor 2P connector (C) on the driver's seat position sensor harness.

  4. Install the recline cover.

  5. Do the battery terminal reconnection procedure.

  6. Clear any DTCs with the HDS.

  7. Check the operation of the driver's seat position sensor with the HDS.

  8. Confirm proper SRS operation: Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

See also:

Manual Transmission Disassembly (M/T)
Exploded View - Clutch Housing ...

Previous Destinations
DEST button ► Previous Destinations Select an address from a list of your 50 most recent destinations to use as the destination. The list is displayed with the most recent destination at t ...

Driver's Seat Position Sensor Operation Check
Check the driver's seat position sensor after the driver's seat position sensor replacement. Make sure the driver's seat is all the way forward position. Make sure the ...

© 2026 Copyright www.hfitinfo.com