Honda Fit: ODS Unit Replacement
Removal
-
Do the battery terminal disconnection procedure, then wait at least 3 minutes before starting work.
-
Disconnect the passenger's side airbag harness 2P connector.
-
Remove the front passenger's seat-back cover/pad.
-
Remove the cover (A), then disconnect the ODS unit 18P connector (B) and OPDS sensor connectors (C) from the ODS unit (D).
-
Remove the two bolts (E) and the ODS unit.
Installation
-
Place the ODS unit (A) on the seat-back frame. Tighten the two bolts (B).
-
Connect the ODS unit harness 18P connector (C) and OPDS sensor connectors (D) to the ODS unit. Reinstall the cover (E).
-
Install the front passenger's seat-back cover.
-
Install the front passenger's seat assembly, then connect the side airbag harness 2P connector.
-
Do the battery terminal reconnection procedure.
-
Set the seat-back in the normal position, and make sure there is nothing on the front passenger's seat.
-
Clear any DTCs with the HDS.
-
Do the OPDS sensor initialization.
-
Confirm proper SRS operation: Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.
See also:
Combination Light Switch Test/Replacement
Remove the steering column covers.
Disconnect the 12P connector (A) from the combination light switch (B).
@font-face{font-family:
"Honda_Symb ...
Rocker Arm Assembly Removal
Remove the cylinder head cover.
Loosen the rocker arm adjusting screws (A).
Unscrew the rocker shaft mounting bolts two turns at a time in the
sequence shown.
...
Towing
If the vehicle needs to be towed, call a professional towing service. Never
tow the vehicle behind another vehicle with just a rope or chain. It is very
dangerous.
Emergency Towing -There are thr ...
Categories
