When tightening the TORX nuts (A), begin with ?, and tighten them in a crisscross pattern in two or more steps.
Connect the front passenger's weight sensor connectors (B).
NOTE: The sensor connectors with the white tape (C) connect to the front sensors.
Reassemble the front passenger's seat cushion cover/pad.
Reinstall the front passenger's seat.
Do the battery terminal reconnection procedure.
Clear any DTCs with the HDS.
Do the front passenger's weight sensor initialization.
Confirm proper SRS operation: Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.
About Your Seat Belts
Seat belts are the single most effective safety device because they keep you
connected to the vehicle so that you can take advantage of many built-in safety
features. They also help keep you from be ...
Front Passenger's Weight Sensor Output Check After a Vehicle Collision
NOTE: Check the front passenger's weight sensor output after this action:
After a vehicle collision
Pre-Operation Check Set-up
Make sure all the components of the front passeng ...
CMP Pulse Plate Removal and Installation
Removal
Remove the air cleaner.
Remove the intake manifold chamber.
Disconnect the following engine wire harness connectors, and remove the
wire harness clamps ...