Honda Fit: Front Passenger's Weight Sensor Replacement (Part-1)
Removal
NOTE: .
-
Removal of the front passenger's weight sensors must be done according to precautions and procedures.
-
The front passenger's weight sensor are part of the seat track and must be replaced as an assembly.
-
Do the battery terminal disconnection procedure, then wait at least 3 minutes before starting work.
-
Remove the front passenger's seat.
-
Remove the cushion cover/pad from the seat cushion frame.
-
Remove the TORX nuts (A) attaching the seat track (B) to the weight sensors (C) using a TORX E18 socket.
-
Disconnect the front passenger's weight sensor connectors (D), then remove the front passenger's seat slide assembly (E) including both passenger's weight sensors.
Installation
NOTE:
-
Be sure to install the harness wires so they are not pinched or interfere with other parts.
-
The front passenger's weight sensor are part of the seat track and must be replaced as an assembly.
-
The spacers and collars can be identified by their color. Make sure to install the spacers and collars as shown.
-
Install the new front passenger's seat slide assembly under the seat track.
See also:
Inspection and Maintenance
For your safety, perform all listed inspections and maintenance to keep your
vehicle
in good condition. If you become aware of any abnormality (noise, smell,
insufficient
brake fluid, oil residu ...
Immobilizer System
The immobilizer system protects your vehicle from theft. If an improperly-coded
key (or other device) is used, the engine’s fuel system is disabled.
When you turn the ignition switch to the ON (I ...
Changing the Rear Wiper Blade Rubber
1. Raise the wiper arm off.
2. Pivot up the bottom end of the wiper blade
until it comes off from the wiper arm.
3. Slide the wiper blade out from the end with
the indent.
NOTICE
Avoid dro ...
Categories
